FSF addresses used in PA sources are no longer valid and rpmlint
generates numerous warnings during packaging because of this.
This patch changes all FSF addresses to FSF web page according to
the GPL how-to: https://www.gnu.org/licenses/gpl-howto.en.html
Done automatically by sed-ing through sources.
In case a transport is currently disconnected and transitions to
idle, that should not count as a "remote hang up" event.
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
Parse the gain changed AT commands from the headset and fire 2 new
hooks as a result. The device will connect to those hooks and change the
source/sink volumes.
When the source/sink volume changes, set the gain on the microphone or
speaker respectively. Make sure we do nothing if the transport can not
handle the gain changes.
If the transport for the profile doesn't exist, the old behaviour was
to leave cp->available at the default value, which is
PA_AVAILABLE_UNKNOWN, but if there's no transport, the profile should
be marked as unavailable.
This commit adds basic support for devices implementing HSP Headset
Unit, HSP Audio Gateway, HFP Handsfree Unit, HFP Audio Gateway to the
BlueZ 5 bluetooth audio devices driver module (module-bluez5-device).
The code in the "io_fail" section was only used for HUP handling, but
there were jumps to there also from places where reading or writing
failed, because the read/write failure could have been caused by HUP.
This patch simplifies things by checking for HUP condition before
trying to read or write. Now if reading or writing fails, we will
jump to "fail" directly instead of going via the "io_fail" label. As
a result, the "io_fail" label isn't needed any more.
This name is more acurate with regards of what role we're currently
playing and we've already been using it in
pa_bluetooth_profile_to_string() since 449d6cb.
Currently the latency information is being updated based on the encoded
SBC data instead of the decoded PCM data. Fixing this required moving
the timing update to be after the packet has been decoded.
The Nokia E7 running Symbian Belle Refresh seems to generate invalid SBC
packets every few minutes. This causes pulseaudio to disconnect the
stream and log "SBC decoding error (-3)".
If a single packet is bad, pulseaudio should keep playing the stream.
When setting attribute foo, or in this case the card profile, in my
opinion the thing passed to the set_foo() function should be of the
type of foo, not a string identifier that can be used to search for
the actual foo in set_foo().
This is mostly a question of taste, but there's at least some small
benefit from passing the actual object: often the profile object is
already available when calling pa_card_set_profile(), so passing the
card name would cause unnecessary searching when pa_card_set_profile()
needs to look up the profile from the hashmap.
For quite some time now the device driver module doesn't work well
without the discovery module, so for the BlueZ 5 support we'll prevent
the device driver module to be loaded if the discovery module is not
loaded.
Create the thread function, the render and push functions for A2DP, the
process message function for communication between the I/O thread and
the main thread, and other helper functions related to them.
Get the remote device information stored in pa_bluetooth_discovery. This
also creates the mandatory parameter 'path' for module-bluez5-device,
which is used to inform the object path of the remote device in BlueZ on
the module load.
