FSF addresses used in PA sources are no longer valid and rpmlint
generates numerous warnings during packaging because of this.
This patch changes all FSF addresses to FSF web page according to
the GPL how-to: https://www.gnu.org/licenses/gpl-howto.en.html
Done automatically by sed-ing through sources.
It's fairly uncommon, but it happens that jack detection is enabled
for some reason, e g hardware design. In that case, we cannot use
jack detection, but we can still use the hint to pick up that there
is a path.
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
The IDT/Sigmatel codec driver often creates a "Mic Jack Mode" for
every mic jack, so it can change functionality between Mic and Line In.
However, as the "Mic Jack" is the standard naming, our current solution
does not make the Line In port unavailable when nothing is plugged in.
This patch makes the "Line In" port not to be created just because there
is a "Mic Jack Mode" that could be set to "Line". This makes the behaviour
consistent with e g "Dock Mic Jack Mode", "Front Mic Jack Mode" etc, where
we don't create a "Dock Line" or "Dock Mic" port either.
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
Support the new jack detection interface implemented in Linux 3.3
(and Ubuntu's 3.2 kernel).
Jacks are probed and detected using the snd_hctl_* commands, which
means we need to listen to them using fdlists. As this detection
needs to be active even if there is currently no sink for the jack,
so this polling is done on the card level.
Also add configuration support in paths, like this:
[Jack Headphone]
required-any = any
...where 'Jack Headphone' should match 'Headphone Jack' as given by
ALSA (as seen in e g 'amixer controls').
"Required", "required-any" and "required-absent" is supported. Using
required-any, one can have several ports even though there is no
other indication in the mixer that this path exists.
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
Just like we turn off the "Front Mic" element when we select "Rear Mic",
we should also turn off the "Front Mic Boost" element. And the same for
the other inputs.
Reported-by: Len Owens <len@ovenwerks.net>
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
The priorities should be set in the approximately likeliness that someone
would like to use them. This is hard to guess of course, but this is
a better guess compared to the existing configuration.
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
Completely rework mixer logic. This now allows controlling a full set of
elements from a single sink's volume slider/mute button.
This also introduces sink and source "ports" that can be used to choose
different input or output ports with the UI. (i.e. "mic"/"line-in" or
"speaker"/"headphones".
The mixer paths and device maps are now configered in external
configuration files and can be tweaked as necessary.
