It's fairly uncommon, but it happens that jack detection is enabled
for some reason, e g hardware design. In that case, we cannot use
jack detection, but we can still use the hint to pick up that there
is a path.
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
Support the new jack detection interface implemented in Linux 3.3
(and Ubuntu's 3.2 kernel).
Jacks are probed and detected using the snd_hctl_* commands, which
means we need to listen to them using fdlists. As this detection
needs to be active even if there is currently no sink for the jack,
so this polling is done on the card level.
Also add configuration support in paths, like this:
[Jack Headphone]
required-any = any
...where 'Jack Headphone' should match 'Headphone Jack' as given by
ALSA (as seen in e g 'amixer controls').
"Required", "required-any" and "required-absent" is supported. Using
required-any, one can have several ports even though there is no
other indication in the mixer that this path exists.
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
Just like we turn off the "Front Mic" element when we select "Rear Mic",
we should also turn off the "Front Mic Boost" element. And the same for
the other inputs.
Reported-by: Len Owens <len@ovenwerks.net>
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
The priorities should be set in the approximately likeliness that someone
would like to use them. This is hard to guess of course, but this is
a better guess compared to the existing configuration.
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
Make sure that mic and line (with common names) use the specific
path instead of the analog-input one.
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
