Add the output from its sink-input attached callback and remove it
again from the detach callback. This simplifies some output_enable
and we can also avoid posting 2 messages for the sink.
A value of 0 for adjust_time should disable rate adjustment.
Fix a bug where a 0 value causes rate adjustment to be called
continuously instead after an unsuspend event.
The outputs are removed from the idxset before output_free() is
called. Trying to remove them again in output_free(), and asserting
that it should succeed caused crashing whenever outputs were freed.
This bug was introduced in commit
061878b5a4.
BugLink: https://bugs.freedesktop.org/show_bug.cgi?id=65901
Since some devices can be chatty with regards to how often they return
from poll(), this adds a PA_UNLIKELY() to all the the rewind_requested
checks in our sink modules to make the general case (no rewind was
requested) the fast path.
When a rewind is requested on a sink input, the request parameters are
stored in the pa_sink_input struct. The parameters are reset during
rewind processing, and if the sink decides to ignore the rewind
request due to being suspended, stale parameters are left in
pa_sink_input. It's particularly problematic if the rewrite_bytes
parameter is left at -1, because that will prevent all future rewind
processing on that sink input. So, in order to avoid stale parameters,
every rewind request needs to be processed, even if the sink is
suspended.
Reported-by: Uoti Urpala
Previously thread_func() used PA_SINK_IS_OPENED() to check whether
some data should be rendered. process_render_null() used a different
check: it would return immediately if the sink was not in the RUNNING
state. This caused a busy loop when the sink was in the IDLE state,
because process_render_null() didn't update the timestamp, and
thread_func() still kept the timer active using the old timestamp.
pa_rtpoll_run() would return immediately because of the old timestamp.
This is fixed by using the same check in both thread_func() and
process_render_null(). Since the checks are the same, it's actually
redundant to have the check in process_render_null(), so it is now an
assertion.
BugLink: https://bugs.freedesktop.org/show_bug.cgi?id=54779
These are not used for anything at this point, but this
makes it easy to add ad-hoc debug prints that show the
memblockq name and to convert between bytes and usecs.
The smoother is paused on initialization and resumed when the sink
state is set to running. Otherwise, early latency estimates are
too low since there is some delay between module initialization and
entering the running state.
After the smoother is initially resumed, it is paused when the sink
state is not running. The previous behavior was to pause only when
the sink enters suspended state, however, this would lead to large
errors in latency estimates after the sink has been idle for some
time.
This is the beginning of work to support compressed formats natively in
PulseAudio. This adds a pa_stream_new_extended() that takes a format
structure, sends it to the server (=> protocol extension) and has the
server negotiate with the appropropriate sink to figure out what format
it should use.
This is work in progress, and works only with PCM streams. Actual
compressed format support in some sink needs to be implemented, and
extensive testing is required.
More details on how this is supposed to work is available at:
http://pulseaudio.org/wiki/PassthroughSupport
