Keep track of the param changes with the user counter. Make sure to
flip the serial switch whenever a change is pending. Previously
we copied the param from the channelmixer or follower but that
did not always result in a serial change.
Fixes#764
Not all devices report their A2DP delay. In those cases, use a fallback
value of 150ms by default.
Make the delay adjustable with a SPA_Prop, and expose it as a part of
the route. Implement the corresponding parts in media-session.
Keep track of the subelement we're iterating in the result index upper
bits. Use enum_sync to iterate each param and switch to the next
element when we run out of params.
See !468
In BT_DEFER_SETUP mode, when a connection is accepted, the listening
socket is unblocked but the effective connection setup happens only on
first receive, allowing to configure the accepted socket.
First read from the accepted socket is non-blocking and returns a zero
length buffer.
The Pro Audio profile exposes all devices and subdevices with maximum
channel count and no channel layout. It also have no hardware volume
and is more suited for Pro Audio usage.
See #731#704#57
Set initial device profile according to what's connected at startup,
rather than having media-session try to set it to A2DP (and fail, if the
profile was not connected, resulting to startup in null profile).
This avoids making a codec switch at device startup (we'll stay with
what BlueZ autoconnected us to, usually the previously used codec).
Release the transport if it went idle, ensuring that the fd is closed,
and add safeguards we won't double-acquire/release it.
This can occur if the device pauses the playback. The transport may also
activate again later on, and in this case we need to reacquire a new fd.
Not closing the old fd causes problems in this case.
However, apparently the BlueZ Release() call fails if the transport is
idle. We just ignore the error and downgrade the error message; it might
not be safe to not call Release() because the idle property update is
async.
Make a2dp clock advance at the correct rate.
Revert back to accumulating to a single buffer before sending it out.
What it did previously seemed hard to get to work properly with e.g.
aptx which produces block of varying sizes on decoding.
Implement monitor volumes in the merger. There are two volumes,
the channel volume and the monitor volume. The monitor volume
is always applied.
By default the monitor volume will now follow the main volume of
the node. This can be disabled with a monitor.channel-volumes
property.
See #674
