SPA_MEMBER is misleading, all we're doing here is pointer+offset and a
type-casting the result. Rename to SPA_PTROFF which is more expressive (and
has the same number of characters so we don't need to re-indent).
When a device as added in dbus but we already knew about the
device, don't assert but reuse the device we already have.
Seems to happen when resuming from suspend.
See rhbz#1948776
Make a new softVolume property that contains only the soft volume
to apply.
In the case of HW/SW volume, we pass the real volume in the
channelVolume and the leftover volume in softVolume. We don't
use the monitorVolume for this anymore because it is a completely
separate volume handled by the merger node.
This way, channelVolume always represents the effective volume
set on routes, channelmix and merger and only the softVolume (when
available) is applied as software volume by channelmix.
This makes things map a bit better to what is actually happening with
the real volume and leftover software volumes after applying the
hardware volumes in the device.
With this change, the volume on the monitor is not affected by the
sink volume anymore and we can use the monitorVolume for this later.
This also means that the monitor volume in pavucontrol of the sinks
does not change when the sink volume changes. PulseAudio is inconsistent
here: If the volume is HW, the monitor volume is not affected, if the
volume is SW, it is. In PipeWire there is an option in merger to
let the volume affect the monitor with monitor.channel-volumes = true.
This apparently causes delays in shutdown under some conditions, and
closing the DBus connection should be enought to tell BlueZ that we are
shutting down.
Move the icon we get from bluez to a separate property, it is not
a good icon to show.
Copy form factor from device to node properties.
Set device.bus in the device properties and copy it to the node
properties.
Use form factor and bus to make a nice icon-name for the node and
device.
Fixes#1064
Add necessary apis to bluez transport.
Add A2DP(AVRCP) absolute volume support. Source volume can only update to adapter node but not from due to AG nodes don't have route.
Since A2DP/HSP/HFP volume is already percentage itself, it has been mapped to pulseaudio volume then converting to linear volume.
In case headset fails to reply with AT+BCS to the codec selection
following AT+CMER, try to retry the codec selection, and if it still
fails, assume the headset is configured for CVSD.
There won't be further battery level updates when RFCOMM connection is
down, so remove the battery then.
Fix minor things with canceling the provider registration.
Let codec decides when rtp packet need to be sent (terminated by MTU size in most case).
LDAC encoding loop can now be terminated by reading if frame_num is written, no 'frame_count' updating is needed.
RTP payload fragmentation can now be implemented more easily based on this.
Auto-connect all paired & trusted devices on startup.
Since devices that already connected or powering off would reject the connecting requests, it should be fine with this behavior.
Also reconnect remaining profiles if only partial profiles are connected.
If oFono or hsphfpd are not installed, just log an info message
that they are not used. The native backend will work fine and we
don't want to log warnings.
See #971
So that we can know if this node has routes or not.
Nodes without routes might need their volumes restored directly
with the node properties, like streams. Nodes with a route need their
volumes set on the device managing the node.
When I enforing HFP codec switching between HFP profiles, it has a chance of being aborted by ECONNABORTED. Seems a retry is sufficient for work around it.
