In media-sink, there's no need to set RCVBUF.
In media-source, we don't need to set NONBLOCK, as reads are done with
DONTWAIT. Don't set SNDBUF as it's not needed there. Don't set RCVBUF,
but use the (big) kernel default value: decode-buffer will handle any
overruns. Small values of RCVBUF might cause problems if kernel is
sending packets in a burst faster than we wake up.
On underflow in sources, pad with explicit silence. This avoids the
audioadapter from getting off sync from the cycle. That causes problems
as driver when we want to produce a buffer only a the start of the
cycle.
In some cases, it's also possible that the io already has buffer at the
start of the cycle when rate matching as driver. Currently, we don't
produce buffer in this case, but we should. Fix that by doing things in
the exact same way as ALSA sources do.
The maximum receive buffer target of 6 packets may be too small when
there's huge jitter in reception. Increase it so that we may use all
buffer available if needed (2*quantum_limit = 370 ms @ 44100).
For SCO, explicitly set maximum buffer to 40 ms, so that latency cannot
grow too large there. For A2DP duplex, set it to 80 ms for same reason.
These are close to the old 6*packet limit.
For BAP server audio sink, set buffering target so that we try to match
the target presentation delay. Also adjust requested node latency to be
smaller than the delay.
Also fix BAP transport presentation delay value parsing, and parse also
the other BAP transport properties. Of these, transport latency value
needs to be taken into account in the total sink latency.
When reading the timerfd gives an error, we should return right away
because the timeout did not happen.
If we change the timerfd timeout before reading it, we can get -EAGAIN.
Don't log an error in that case but wait for the new timeout.
The graph cycle goes: driver timeout -> process output nodes -> process
driver node. Hence, driver should produce buffers in the timeout,
otherwise there's one quantum extra latency.
Make the bluez5 media/sco sources as drivers put a buffer to io before
indicating ready, and as follower do it in process. Also make checks if
io == NULL, and don't set io->status to HAVE_DATA unless there really is
a buffer ready.
Driver timeouts need to be started/stopped when we switch from follower
to driver or vice versa.
The BT sources fail to do this, so fix it. Sinks already do it right.
For backward compatibility with old Wireplumber releases, support the
old api.bluez5.a2dp.sink/source names, and use them in object events
instead of the media.sink/source names.
We can't determine which remote endpoint or device the
SelectConfiguration() call is associated with. For LE Audio BAP, as this
method is called only for the Initiator we set the whole instance as a
Central/Initiator.
This flag is unset on BAP media endpoint removal.
