The pulse API uses either the node.name or object.serials so pass this
along in the TARGET_OBJECT instead of the NODE_TARGET now that
wireplumber handles this.
When we start the drain, we unpause the stream. When we conplete the
drain, we unpause again, which does nothing when the stream was already
unpaused. However, this leaves the drained state on the stream and so
the stream will never be able to play new data.
Trigger a new pw_stream_set_active() with the current stream state to
clear the drained state.
Fixes#2928
Incompatible changes between ROC v0.1.X and v0.2.X require
adjusting the ROC modules' code. The largest change is going
from `roc_address` to `roc_endpoint`. There is also a breaking
change, the removal of `local.ip` parameter from module-roc-sink
as `roc_sender_bind()` has been removed.
The API usage was modelled after https://github.com/roc-streaming/roc-pulse
See #1757Fixes#2911
Add a new config section that can contain a set of commands to run after
starting.
There is only load-module available now but it can be used to remove the
dependency on pactl when starting the server.
Only enable pulse.idle.timeout for selected applications
(speech-dispatcher) and let other applications be. We can also
lower the minreq and min-quantum of speech-dispatcher now.
Fixes#2880
Connect the playback stream before the capture stream since the capture
stream can otherwise trigger playback_process() before the playback node
has been activated.
Modules echo-cancel, filter-chain and loopback may print errors if no
applicable target nodes exist when they start up. For our products this
is not considered error/warning worthy, since the issue will resolve
itself once the target nodes exist.
We don't need to pass the client to the module create and load
functions, they can work without a client.
The only place the client is used is to access the properties to make a
new connection to pipewire. This is also however not a good idea, we
should simply use the defaults used by the context or else a client
could set strange properties like remote.name etc for these internal
connections.
Also removing the dependency of the client will make it possible to load
modules from the startup script or other modules later.
First set some of the port flags and data, especially the owner_data
before calling pw_impl_port_set_mix(), which will use the owner_data
to send the mix_info.
See #2847
We don't always need to send buffers to a remote port, when the port
is an output port, all the mix ports use the same buffers. This means
that when we add another link to a port, we don't get the mix_info
anymore and then we don't know the peer_id and we don't complete the
link and we don't call the connection_callback.
Instead, send the mix_info right before sending the Buffer Io area. We
always do this for all mix io and after we have sent the buffers so this
is a better place.
Fixes#2841
When a client is not sending any data when it should be and causes an
underrun, mark it as idle and record the timestamp.
When a client is idle for pulse.idle.timeout seconds, set the stream
as inactive. When more data is received, set it back to active.
Add a pulse.idle.timeout option to set a global server default or
a per-stream value. Set the server default to 5 seconds. A value of 0
can be used to disable this feature.
With this change, badly behaving clients that are not sending any data
will be paused so that the sinks can suspend to save battery power.
Fixes#2839
