Wait until we have linked the stream to a device or stream before
we emit the READY state. This is what pulseaudio expects.
Remove stream_index from disconnecting stream so that we don't
accidentally use it again. It is possible that we already created a
new stream with the same id before the old stream could complete the
disconnect.
This ensures we first finish all pending operations and then get
notifications of the new events. Brings pactl subscribe in line
with what it does on real PulseAudio.
First sync the globals and if no global created new pending operations,
run through the operations. This ensures no operation is run before
all globals have data.
When a stream does not specify ADJUST_LATENCY, use some slightly
different metrics to implement the readable_size. We want the app
to fill as much space as possible. Makes mplayer work and paplay
use the right amount of buffering.
Before the node is started, we don't get a Format parameters and we
don't know the channelmap of the node. This forces us to invent a
channelmap that might be wrong. We can do better by using the
EnumFormat param to extract some defaults for the format, rate and
channelmap. Fixes wrong channels in gnome-control-center when testing
speakers.
A sink and source can have an array of pa_format_info structures
that contain the possible formats of the device. Parse them from
the EnumFormat and return them when introspecting.
The drain operation does not complete with a sync from the server but
with an event from the stream. Set a flag in the operation that it
completes with a sync. Keep all operations without a sync around in
the list.
Unknown channel names are mapped to aux channels.
Add extra AUX channels when we don't know the channel layout.
This makes sure apps always receive valid channel layouts so they
don't abort (pactl).
Repect minreq and fragsize for playback and capture.
Try to configure tlength at 2 seconds, minreq at around 25ms. Should
greatly improve compatibility with audacious and mpv.
Count since_underrun correctly.
Fixes#278
First move all completed operations to a new list, then complete
the operations and cancel the ones that are not completed correctly.
This ensures that new operations from the callbacks don't get
completed immediately as well.
Track the current route and the properties independently. Else we
might skip parsing the volumes/mute properties when the current
route didn't change.
Fixes#281
Use a global sync that both syncs the globals and completes the
operations.
In the case of a card profile change, first the nodes are removed
and added and then the Profile and Route info updated. We need to
be able to bind to the new node and get the device.profile.id
before we can find the active port of the node.
See #279
