- foot.ini.5: mention location of example config file
- foot.1: replace outdated (or incomplete) information about the
location of the config file with references to foot.ini.5
- foot.1 and foot.ini.5: conform to scdoc specification, thus surround each
header with (at least) one blank line. additionally consistently use exactly
one line before/after each header (was sometimes two before)
- foot.1: some parts of the keybindings had their own section, move into
KEYBOARD SHORTCUTS section
- foot.1: move EXIT STATUS section to the end where it is commonly found
- foot.1: copy information about config file handling from the beginning of
foot.ini.5 into the CONFIGURATION section of foot.1
- INSTALL.md: foot.ini is no longer included in the documentation
- meson.build: do not bundle foot.ini with documentation anymore, see also
https://codeberg.org/dnkl/foot/pulls/1015Closes#1002
This makes the example config `foot.ini` and its man page slightly more
coherent regarding the specification of default values.
Note that the cursor color is not hardcoded like e.g. foreground or
background, thus in the example config, `<inverse foreground/background>`
makes more sense.
These work as expected and don't interfere with anything else.
They are useful on the increasing number of keyboards with custom
firmware. The keycodes enable using the same key combination
for terminals as other apps.
For example: by holding down a layer-switching key with a thumb, the
Copy and Paste key codes can be assigned to the C and V keys on a secondary
layer, making for a natural universal copy/paste key combination.
This patch adds support for DECRQSS (request Selection or Setting),
for the following sub-queries:
* DECSTBM Set Top and Bottom Margins
* SGR Set Graphic Rendition
* DECSCUSR Set Cursor Style
Closes#798
This allows you to configure custom colors to be used when colors are
being dimmed (`\E[2m`).
It is implemented by color matching (just like
bold-text-in-bright=palette-based); the color-to-be-dimmed is matched
against the current color palette.
If it matches one of the regular colors (colors 0-7), the
corresponding “dim” color will be used.
If it matches one of the bright colors (colors 8-15), the
corresponding “regular” color will be used (but *only* if the “dim”
color has been set).
Otherwise, the color is dimmed by reducing its luminance.
The default behavior, i.e. when dim0-7 hasn’t been configured, is to
dim by reducing luminance for *all* colors. I.e. we don’t do any color
matching at all. In particular, this means that dimming a bright color
will *not* result in the corresponding “regular” color.
Closes#776
